-
Notifications
You must be signed in to change notification settings - Fork 18
agio and agopengps networking
lansalot edited this page Jan 10, 2025
·
4 revisions
Per the udp section, you're going to be using ethernet cables.
Check this section out over at the AgOpenGPS wiki on how to set up networking. Ethernet Setup
Communication message formats are documented here
- All-In-One Board versions and how to order
- Assembling the board
- Other pieces to be able to assemble
- Ampseal 23 pinout
- Ampseal-Wiring-Harness example
- Machine Board for relay control
- Machine board - full guide
- Rate Controller for variable rate and section
- GNSS / GPS - ZED-F9P
- GNSS Antenna
- Teensy 4.1 a.k.a the brain of the board
- IMU for roll compensation
- Wheel Angle Sensor
- Windows Tablet
- Cytron MD13S driver
- Steering with Motor
- Steering with Baraki hydraulic block
- Steering via CAN bus
- Steering via Danfoss
- Steering with Keya CANBUS wheel
- Connectors
- Cabling and Wiring
- Miscellaneous hardware