-
Notifications
You must be signed in to change notification settings - Fork 7
List of Materials
Rafael Zenaro edited this page Aug 10, 2024
·
13 revisions
If you want a easy way to build without messing with wires and solder bridges, We design a custom PCB to fit every compoment. You can check/order one HERE: Gameboy Printer Emulator - ESP32 PCB
If you choose this option, you can find a config.h already configured to this, inside the config.h presets/ESP32 Devkit 38pins folder.
| Piece | Where to buy | Notes |
|---|---|---|
| ESP 32 Dev Board | AliExpress | If you plan to use the PCB, you must get a 38pins version |
| Bidirectional Level Shifter | AliExpress | |
| SD Card Reader | AliExpress | |
| Push Button | AliExpress | Attach a 5k or 10k resistor to the GND to act as a Pull Down |
| 5k or 10k resistor | AliExpress | |
| GameBoy Link Cable | AliExpress |
| Piece | Where to buy | Notes |
|---|---|---|
| GameBoy Link Cable Breakout Board | OSH Park | This prevent you from cutting the Link Cable in half |
| GameBoy Advance Link Port | AliExpress | In case if you don't want the Breakout board |
| RGB LED | AliExpress | You can use both LEDs (RGB and single color), or just one of then |
| LED | AliExpress | You can use both LEDs (RGB and single color), or just one of then |
| 220 or 500 Ohm Resistor | AliExpress | Connect one to each positive leg of the LED |
| 128x32 OLED Display | AliExpress |