Steps to connect USB UART Cable
Follow the steps below to connect USB-UART Cable to the Flyport node:
-
Connect USB-UART cable to the UART pin out of Flyport to load HEX file in to the program memory of the Flyport module.
The Pinouts of USB-UART (FTDI) cable are mentioned below:- Black--> Ground
- CTS --> Brown
- VCC --> Red
- TXD --> Orange
- RXD --> Yellow
- RTS --> Green
-
Connect this to the Flyport as shown in picture below
-
Connect the USB-UART Bridge to the Flyport and Open Device manager to check COM port at which your USB-UART Bridge is connected mentioned as USB serial PORT. (Go to RUN then write devmgmt.msc)
