Skip to content

Latest commit

 

History

History
65 lines (55 loc) · 2.88 KB

connect.md

File metadata and controls

65 lines (55 loc) · 2.88 KB

Connect to device

中文

Windows

RFCOMM (preferred)

  1. Pair your device in system settings
  2. Make sure your device is not connected to other Bluetooth host
    (Disconnected or connected to the host you are using)
  3. Open this app
  4. Go to Device panel
  5. Click Search RFCOMM, wait until your device name appears
  6. Click your device name in the list, the MAC address at the bottom will be updated
  7. Click Connect
  8. Go to Generic Device panel after Device Connected is shown at the bottom
  9. (Optional) Click Read Settings to sync settings from device

BLE (not recommended)

It's nearly impossible to connect to device on Windows using BLE due to the limitation in Qt API and the randomized Bluetooth MAC addresses on some devices. However, you could still try these steps if you want.

  1. Pair your device in system settings
  2. Make sure your device is connected to any Bluetooth host, but not controlled by other Edifier Connect app or mEDIFIER app
  3. Remove all devices named EDIFIER BLE in the system settings
  4. Connect to the device named EDIFIER BLE in the system settings
    (This might fail for some devices)
  5. Open this app
  6. Go to Device panel
  7. Click Search BLE, wait for a while
  8. Click the device named EDIFIER BLE, the MAC address at the bottom will be updated
  9. Click Connect
  10. Go to Generic Device panel after Device Connected is shown at the bottom
  11. (Optional) Click Read Settings to sync settings from device

Android

RFCOMM

  1. Pair your device in system settings
  2. Make sure your device is not connected to other Bluetooth host
    (Disconnected or connected to the host you are using)
  3. Open this app
  4. Go to Device panel
  5. Click Search RFCOMM, wait until your device name appears
  6. Click your device name in the list, the MAC address at the bottom will be updated
  7. Click Connect
  8. Go to Generic Device panel after Device Connected is shown
  9. (Optional) Click Read Settings to sync settings from device

BLE (preferred)

  1. Pair your device in system settings
  2. Make sure your device is connected to any Bluetooth host, but not controlled by other Edifier Connect app or mEDIFIER app
  3. Open this app
  4. Go to Device panel
  5. Click Search BLE, wait for a while
  6. Click the device named EDIFIER BLE, the MAC address at the bottom will be updated
  7. Click Connect
  8. Go to Generic Device panel after Device Connected is shown
  9. (Optional) Click Read Settings to sync settings from device

Linux & macOS

This app theoretically works on Linux and macOS, but I don't have the environments to test it. You could try the steps for Windows and Android above.

Connect without searching

It's possible to connect to a paired device without searching.
This app remembers the MAC address and the connection type you used last time. You can try to click Connect without searching. It works sometimes.