rtorrent.rc

# Snsapshot taken on 8/20/2018 - rtorrent 0.9.7


# Maximum and minimum number of peers to connect to per torrent.
min_peers = 1
max_peers = 1000

# Same as above but for seeding completed torrents (-1 = same as downloading)
min_peers_seed = -1
max_peers_seed = -1

# Maximum number of simultaneous uploads per torrent.
max_uploads = 1000

# Global upload and download rate in KiB. "0" for unlimited.
#download_rate = 0
#upload_rate = 0

# Default directory to save the downloaded torrents.
directory = /home/duke/Torrent_Downloads

# Default session directory. Make sure you don't run multiple instance
# of rtorrent using the same session directory. Perhaps using a
# relative path?
session = /home/duke/Torrent_Downloads/.session

# Watch a directory for new torrents, and stop those that have been
# deleted.
schedule = watch_directory,5,5,"load.start=/home/duke/Torrent_Files/*.torrent,d.delete_tied="

# Close torrents when diskspace is low.
schedule = low_diskspace,5,60,close_low_diskspace=10240M

# The ip address reported to the tracker.
#ip = 127.0.0.1
#ip = rakshasa.no

# The ip address the listening socket and outgoing connections is
# bound to.
#bind = 127.0.0.1
#bind = rakshasa.no

# Port range to use for listening.
port_range = 55950-56000

# Start opening ports at a random position within the port range.
port_random = yes

# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.
check_hash = yes

# Set whether the client should try to connect to UDP trackers.
trackers.use_udp.set = yes

# Alternative calls to bind and ip that should handle dynamic ip's.
#schedule = ip_tick,0,1800,ip=rakshasa
#schedule = bind_tick,0,1800,bind=rakshasa

# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext

# The example value allows incoming encrypted connections, starts unencrypted
# outgoing connections but retries with encryption if they fail, preferring
# plaintext to RC4 encryption after the encrypted handshake
#
encryption = allow_incoming,enable_retry,prefer_plaintext

# Enable DHT support for trackerless torrents or when all trackers are down.
# May be set to "disable" (completely disable DHT), "off" (do not start DHT),
# "auto" (start and stop DHT as needed), or "on" (start DHT immediately).
# The default is "off". For DHT to work, a session directory must be defined.

dht = disable

# UDP port to use for DHT.
#
# dht_port = 6881

# Enable peer exchange (for torrents not marked private)
#
protocol.pex.set = no

# Necessary for communication with Sonarr, Radarr, Flood and Transdroid.
scgi_port = 0.0.0.0:5000

#Execute Filebot (rtorrent-postprocess.sh) upon completion.
method.set_key=event.download.finished,filebot,"execute={/home/duke/Documents/rtorrent-postprocess.sh,$d.base_path=,$d.name=,$d.custom1=}"
# Old code: system.method.set_key=event.download.finished,filebot,"execute={'`pwd`/rtorrent-postprocess.sh',$d.get_base_path=,$d.get_name=,$d.get_custom1=}"


##### THIS AREA BELOW IS NOT NEEDED BUT I'M KEEPING IT IN CASE ####
#scgi_local = "/var/run/rtorrent/rpc.socket"

# Set correct access rights to the socket file ----------+
# so both, lighttpd and rtorrent, could perform          |
# read-write operations                                  v
#schedule = scgi_permission,0,0,"execute.nothrow=chmod,\"g+w,o=\",/var/run/rtorrent/rpc.socket"

#### END UNNECESSARY CONFIG ####