-
Notifications
You must be signed in to change notification settings - Fork 10
Protection
Using polyester covering film to laminate the drone.
- weight (/thickness)
- stiffness
- keeping barometer, sensors, ailerons clear
- Top Flite MonoKote Flexible High-Gloss Polyester Covering Film (Clear) Aliexpress
- 'new stuff' 5
- Hobbyking's covering film
The lens on the nose is difficult to replace and easy to scratch or dislodge (leading to out of focus).
Many use a CPL filter (polarisation) or ND2/ND4 filter (grey filter, helping against over-exposure). a 37mm filter can be fitted with a GoPro Hero 3 adapter.
https://www.rcgroups.com/forums/showpost.php?p=39457952&postcount=2159 https://www.rcgroups.com/forums/showpost.php?p=39460928&postcount=2174 https://www.rcgroups.com/forums/showpost.php?p=39442083&postcount=2089 ===3d printed lenses https://www.thingiverse.com/thing:2907463 https://www.thingiverse.com/thing:3037963
CorrosionX can be used to protect electronics (servos, C.H.U.C.K. except the barometer) from water/corrosion[1][2]
Three routes:
- disco4g can track your drone with 4g and built-in gps, even when you're flying over wifi. Downside: if the drone crashes so hard the system shuts down, the locationing will also shut down.
- Stand-alone trackers can be the solution, showing the GPS location over cellular network:
- note that many cheaper trackers have only LBS (location based positioning based on cell towers nearby, which is generally very coarse and not usable for finding a drone)
- make sure the tracker works on your cell phone network (most people buy a prepaid SIM)
- https://uavcoach.com/find-lost-drone-3-awesome-gps-drone-trackers/
- another route is having an RF or beeping locator beacon in the drone (could be combined with GPS)
- https://www.rcgroups.com/forums/showthread.php?993165-Low-cost-DIY-XBee-GPS-plane-locator
- https://www.cnx-software.com/2018/07/06/esp32-lora-gps-tracker-ttgo-t-beam-board/
This disco-docs
repository is community-driven Wiki.
We happily grant access to anyone who is interested in contributing, just reach out to us on Slack.