[3.3.1.0] DynISF calculates values outside of limit

[KeesV]

I'm having an issue with DynISF after upgrading to 3.3.1.0 from 3.2.0.4.
When I turn on DynISF and the loop runs, I get an error message saying "Profile sensitivity value is outside of hard limit. INSANE VALUE limited to 1000,00".
I looked at the logs and found a huge amount of lines like this:
09:00:21.022 [DefaultDispatcher-worker-2] D/APS: [OpenAPSSMBPlugin.getAverageIsfMgdl():167]: getAverageIsfMgdl() null from 0 values 07-01-2025 03:45:00 iobCobOref1Worker.

When I turn off DynISF everything runs fine.

AndroidAPS.log

Build version: 2ac634c908-2025.01.07
Time of occurrence in the logfile: 09:35:39.486

Note that I tried turning DynISF on and off a couple of times this morning. First time of occurrence was 09:00:18.622.

What I have tried (but unfortunately didn't fix it):

• Leave AAPS running overnight (with DynISF) disabled and try turning DynISF on again in the morning.
• Erase APS results from maintenance menu and restart AAPS

[MilosKozak]

Send me printscreen of TDD from statistics page and then try to reset it there and restart AAPS

[KeesV]

OK, steps I took:

• Take screenshot of TDD statistics (see below)
• Recalculate TDD statistics by pressing the button "Herberekenen"
• Als pressed the "Reset" button at the bottom of the page, just to be sure
• TDD statistics were recalculated by AAPS. Numbers were exactly the same as in the screenshot
• Restarted AAPS
• Enabled DynISF (I had it off before because of this issue)
• Result: Same error is shown...

[MilosKozak]

are you able to build dev branches?

[KeesV]

I should be able to. I don't have a separate phone to test however, so as long as I can safely switch back to main it should be good

[MilosKozak]

i'll prepare more logging version