Problems with the using AreaPostprocessor on a Generated Mesh #28303
-
|
I created a mesh using two instances of AnnularMeshGenerator, that I then stitched, using StitchedMeshGenerato, which I the extruded using AdvancedExtruderGenerator, with bias. I attempted to determine the surface area of the endpoint of the generated mesh with the AreaPostprocessor. It did not work. On previous .e file the AreaPostprocessor worked fine. Any ideas of why it does not work with the generated mesh? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
The culprit was me using find and replace, to replace my previous named boundaries with the new generated boundary names that replaced words with numbers. The use of numbers in the names of the postprocessors seem to have been the issue. |
Beta Was this translation helpful? Give feedback.
The culprit was me using find and replace, to replace my previous named boundaries with the new generated boundary names that replaced words with numbers. The use of numbers in the names of the postprocessors seem to have been the issue.