.device-shelly-dimmer-2.yaml

esphome:
  name: $devicename
  platform: ESP8266
  board: esp8285
  comment: ${devicetype}  



logger:
  baud_rate: 0

#external_components:
# - source:
#      type: git
#      url: https://github.com/rnauber/esphome.git
#      ref: feature/shelly-dimmer
#    refresh: 1min
#    components: [ shelly_dimmer ]

uart:
 tx_pin: 1
 rx_pin: 3
 baud_rate: 115200
 
sensor:
  - platform: ntc
    sensor: temp_resistance_reading
    name: ${friendly_name} Temperature
    unit_of_measurement: "°C"
    accuracy_decimals: 1
    icon: "mdi:thermometer"
    calibration:
      b_constant: 3350
      reference_resistance: 10kOhm
      reference_temperature: 25°C

  - platform: resistance
    id: temp_resistance_reading
    sensor: temp_analog_reading
    configuration: DOWNSTREAM
    resistor: 32kOhm
    
  - platform: adc
    id: temp_analog_reading
    pin: A0
  
  - platform: total_daily_energy
    name: "${friendly_name} daily energy"
    power_id: "shellydimmer2_power"
    device_class: energy
    state_class: total_increasing  #uses total_increasing so HA counts energy correctly.
    filters:
      - multiply: 0.001
    unit_of_measurement: kWh
    
#  - platform: adc
#    pin: VCC
#    name: "$friendly_name VCC"
 
light:
  - platform: shelly_dimmer
    name: ${friendly_name}
    id: thislight
    power:
      name: ${friendly_name} Power
      unit_of_measurement: W
      id: "shellydimmer2_power"
      device_class: power
      state_class: measurement
      accuracy_decimals: 2
    voltage:
      name: ${friendly_name} Voltage
    current:
      name: ${friendly_name} Current
    max_brightness: 500
    firmware:
      version: "51.6"
      update: true    

      
binary_sensor:
  - platform: gpio
    pin:
      number: GPIO12
    name: "$friendly_name Switch 1"
    filters:
      - delayed_on_off: 100ms
 
  - platform: gpio
    pin:
      number: GPIO14
    name: "$friendly_name Switch 2"
    filters:
      - delayed_on_off: 100ms