ZuluSCSI firmware v2025.01.09

[aperezbios]

What's Changed

• USB MSC initiator mode support by @PetteriAimonen in USB MSC initiator mode support #487
• Improve USB MSC initiator support by @PetteriAimonen in Improve USB MSC initiator support #496
• USB MSC Initiator: Improve handling of no targets found by @PetteriAimonen in USB MSC Initiator: Improve handling of no targets found #488
• Improve messaging when no SD card is present/detected by @morio in Move SD card errors for no SD card to debug mode #490
• Allow user to invert Status LED via zuluscsi.ini by @morio in Allow user to invert Status LED via zuluscsi.ini #497

Full Changelog: v2024.12.12...v2025.01.09

This release contains a new RP2040/2350-specific beta-quality feature that allows you to use your modern computer along with a USB-attached ZuluSCSI RP2040 as a USB SCSI controller, enabling you to read and write to SCSI block devices as if they were USB hard drives. Throughput is limited to approximately 768 kilobytes/second, best case, which is a hardware-level limitation of the USB 1.1 controller in the RP2040. Not all variants of ZuluSCSI RP2040 support initiator mode.

• For all red ZuluSCSI RP2040-based boards, simply copy [ZuluSCSI_RP2040_.bin to the SD card you normally use with your ZuluSCSI, and then re-insert the SD card and power it on.

Initiator-capable ZuluSCSI models

• All Full-size ZuluSCSI RP2040 boards
• Full-size (desktop) ZuluSCSI Pico (OSHW) board
• ZuluSCSI Compact RP2040 Rev 2023b
• ZuluSCSI Compact Homebrew Rev 2023b

ZuluSCSI models that do not support initiator mode

• All ZuluSCSI V1.0/V1.1/V1.2-based boards. do not support initiator mode.
• ZuluSCSI Pico Slim (DB25)
• ZuluSCSI Mini
• ZuluSCSI Compact RP2040 Rev 2022a

---

This discussion was created from the release ZuluSCSI firmware v2025.01.09.