Skip to content

Latest commit

 

History

History
69 lines (57 loc) · 2.15 KB

CHANGELOG.md

File metadata and controls

69 lines (57 loc) · 2.15 KB

Changelog

[1.0.4.1] 2024-2-28

Added

  • formatted uart print data

[1.0.4] 2023-11-4

Added

  • AT+NWM - get or set the network working mode (0 = P2P_LORA, 1 = LoRaWAN)
  • AT+PFREQ - configure P2P Frequency (2400000000 - 2500000000)
  • AT+PTP - configure P2P TX power (Max 13)
  • AT+PSF - configure P2P Spreading Factor (1-8 SF5-SF12)
  • AT+PBW - configure P2P Bandwidth (3-BW200 4-BW400 5-BW-800 6-BW1600)
  • AT+PCR - configure P2P Code Rate (0-CR4/5 1-CR4/6 2-CR4/7 3-CR4/8)
  • AT+PPL - configure P2P Preamble Length
  • AT+PSEND - send data in P2P mode
  • AT+PRECV - continuous receive mode (AT+PRECV=0 exit receive mode)

[1.0.3] 2023-10-6

Added

  • AT+HWMODEL Get the string of the hardware mode
  • AT+HWID Get the string of the hardware ID
  • AT+NJM Get or set the network join mode (0 = ABP, 1 = OTAA)
  • AT+DEVADDR Get or set the device address (4 bytes in hex)
  • AT+NWKSKEY Get or set the network session key (16 bytes in hex)
  • AT+APPSKEY Get or set the application session key (16 bytes in hex)
  • AT+NJS Get the join status (0 = not joined, 1 = joined),
  • AT+CFM Set/Get comfirm mode
  • AT+CFS Get the confirmation status of the last AT+SEND (0 = failure, 1 = success)
  • AT+RETY Set/Get the number of retransmissions of Confirm packet data (1-15)

[1.0.2.4] 2023-9-7

Added

  • Increase the MCU crystal calibration, improve the stability of the system.

[1.0.2.3] 2023-9-4

Added

  • 1.Added the setting of timer compensation

Fixed

  • 1.Change the example join logic to prevent conflicts with p2p test mode

[1.0.2.2] - 2023-8-29

Added

  • Add AT+INTERVAL，Set sensor data uplink interval time

Fixed

[1.0.2.1] - 2023-8-29

Added

  • Add a three-axis sensor, RAK1904, which automatically and continuously sends sensor data after join the network
  • Fix classA downlink

Fixed

[1.0.1] - 2023-7-30

Added

AT+CLASS - Set/Get class (0-CLASSA 2-CLASSC) AT+DR - Set/Get datarate (0-5) AT+TCONF - Set/Get RF test config AT+TTX - RF test tx AT+TRX - RF test rx continuously receive mode AT+TRXNOP - RF test terminate an ongoing continuous rx mode

Fixed

[1.0.0] - 2023-7-9

Added

Added AT instruction frame

Fixed