Initial Boot loader for WT32-SC01 Plus, details required

[rarenu]

Hi it is mentioned at "https://openhasp.haswitchplate.com/0.6.3/devices/wireless-tag/" that the WT32-SC01 Plus requires flashing of initial bootloader to work as openHASP. Please share the link for the boot loader file and the associated files along with its memory locations, to make WT32-SC01 Plus as a openHASP terminal. Thank you for the help.

[fvanroie]

Hi,

The bootloader is included in the full firmware binary file which you can download or install from openHASP Web installer Nightly.

Important

When flashing openHASP onto the ESP32 for the first time, you need to flash it over serial using the full firmware binary file. You need to write the full binary to the ESP32 flash chip at address 0x0.

The full binary also contains a bootloader and partition scheme needed to properly boot the ESP32.

https://openhasp.haswitchplate.com/0.7.0/firmware/esp32/

[rarenu]

Thank you for your reply. I appreciate your prompt response. Thank you so much.

…

On Sun, 16 Apr, 2023, 5:41 pm fvanroie, ***@***.***> wrote: Hi, The bootloader is included in the *full* firmware binary file which you can download or install from openHASP Web installer Nightly <https://nightly.openhasp.com/>. Important When flashing openHASP onto the ESP32 for the first time, you need to flash it over serial using the full firmware binary file. You need to write the full binary to the ESP32 flash chip at address 0x0. The full binary also contains a bootloader and partition scheme needed to properly boot the ESP32. https://openhasp.haswitchplate.com/0.7.0/firmware/esp32/ — Reply to this email directly, view it on GitHub <#470 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABOZMCRQH7GSRAGU47LW273XBRRR3ANCNFSM6AAAAAAXAKLBWA> . You are receiving this because you authored the thread.Message ID: ***@***.***>

[stovedoctor]

You have to ground gpio0

[rarenu]

Ok noted, thanks.

…

On Sun, Apr 16, 2023 at 8:07 PM Stovedoctor ***@***.***> wrote: You have to ground gpio0 — Reply to this email directly, view it on GitHub <#470 (reply in thread)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABOZMCSYV7BPI7DC3VP3523XBSCV7ANCNFSM6AAAAAAXAKLBWA> . You are receiving this because you authored the thread.Message ID: ***@***.***>

[rarenu]

Hi, everything works fine with my WT32-SC01-Plus display. Thank you all for your dedication, smart work and time.

…

On Sun, Apr 16, 2023 at 8:35 PM RagoTube ***@***.***> wrote: Ok noted, thanks. On Sun, Apr 16, 2023 at 8:07 PM Stovedoctor ***@***.***> wrote: > You have to ground gpio0 > > — > Reply to this email directly, view it on GitHub > <#470 (reply in thread)>, > or unsubscribe > <https://github.com/notifications/unsubscribe-auth/ABOZMCSYV7BPI7DC3VP3523XBSCV7ANCNFSM6AAAAAAXAKLBWA> > . > You are receiving this because you authored the thread.Message ID: > ***@***.***> >

[fvanroie]

Thanks, enjoy the WT32-SC01 Plus. It's a great device.