X/Y Axis aren't centered after A belt resonance measurement.

[irebane]

K-Shake&Tune module branch

• I confirm using the main branch

Version

5.0.0

Describe the bug and expected behavior

Running tests on Voron Trident 250mm

While running Relative Belts calibration Tool after A belt data measured and tool proceed with B Belt measurements toolhead is not swinging thru the same center point and it starts B Belt measurements from the position at which A belt measurements finished which is shifted both back and right ~10-15mm. It seems that eventually it leads to end result being shifted on the graph even belts have equal tension.

Thank you.

Additional information and klippy.log

No response

[MBOKjr]

This is also present on the AXES_SHAPER_CALIBRATION. Same scenario, after first axis test, the toolhead is no longer centered during the next test.